Hard Copy Exam

Hard Copy Exam

This type of exam is a hard copy exam, which is typically printed and handed out to the students for classroom testing. If your questions involve the use of accompanying materials, such as charts, graphs, diagrams, pictures or illustrations, they must be handed out to the students at the same time.

Quiz Master can produce both the exam, the answer key, and the page(s) of accompanying materials from your question banks. Below are examples of an printed exam and a printed diagram page using Quiz Master. (The diagram page is printed from the browser.)

Notes

The (8071) in question # 1 is the book number. These are optional numbers you can use if you created a question bank from a published source. Printing them on the exam is optional.

Any distracter style ( for example, A- B- C-, 1.2.3., or a.b.c) can be chosen for the exam regardless of how they are defined in the question banks.

Word wrapping is automatic depending on the font style and printer.

Example of Printed Exam

1. (8071) If an engine operates with a low oil pressure and a high oil temperature, the problem may be caused by a

    A) sheared oil pump shaft.
    B) leaking oil dilution valve.
    C) clogged oil cooler annular jacket.

2. (8614) (Refer to figure 4.) Placing the engine master switch and battery switch to the on position, and advancing the power lever allows current to flow from the bus to the

    A) fuel valve, external power receptacles, power lever switch, power lever relay coil, and ignition     solenoid coil.
    B) fuel valve, power lever switch, power lever relay coil, fuel pumps, and one ignition solenoid     contactor.
    C) fuel valve, external power receptacles, undercurrent solenoid contacts, starter solenoid coil, and     ignition solenoid contacts.

3. (8002) A condition that can occur in radial engines but is unlikely to occur in horizontally opposed engines is

    A) zero valve clearance.
    B) valve overlap.
    C) hydraulic lock.

4. (8058) A characteristic of dyna focal engine mounts as applied to aircraft reciprocating engines is that the

    A) shock mounts eliminate the torsional flexing of the powerplant.
    B) engine attaches to the shock mounts at the engine's center of gravity.
    C) shock mounts point toward the engine's center of gravity.

5. (8045) How is proper end-gap clearance on new piston rings assured during the overhaul of an engine?

    A) By using rings specified by the engine manufacturer.
    B) By placing the rings in the cylinder and measuring the end-gap with a feeler gauge.
    C) By accurately measuring and matching the outside diameter of the rings with the inside diameter     of the cylinders.

----------------------------------------------------------------------

Answer Key

Sample Printed Exam

----------------------------------------------------------------------
Question Banks
----------------------------------------------------------------------
1 Powerplant
----------------------------------------------------------------------
Printer Settings
----------------------------------------------------------------------
Book Numbering On
Shuffle Mode On
Scramble Mode On
----------------------------------------------------------------------
Question #, Question Bank #, Book #, Answer, Explanation/Reference...
----------------------------------------------------------------------

1, 1, 8071, B, AC 65-12A
2, 1, 8614, B, EA-ITP-P2
3, 1, 8002, C, AC 65-12A
4, 1, 8058, C, AP
5, 1, 8045, B, AC 65-12A

Quiz Master Standard Edition Ver. 3.0 (c) Hallandales Inc. 1995 - 2002

Sample Printed Exam

Question Diagrams

Powerplant Figure 4 - Starter Generator Circuit